Motoring MAGGIE
Lidmotor
|
-
Currently 4.00/5
- 1
- 2
- 3
- 4
- 5
Rating: 4.0 out of 1 vote
|
You need to have the
Flash Player installed and
a browser with JavaScript support.
|
|
Description
This is my little induction coil light "Maggie" turned into an intergal part of a pulse motor / generator arrangement. Her little paper clip arms are holding a shaft mounted spinning neo magnet that is being driven by the same simple pulse circuit that I have shown in my last few videos. I had to use a 12 volt battery to drive the system because of the terrible friction of this bad-bearing setup. I was surprised that the little 2N2222A held up to this and figure that the 25 ohm rheostat, acting like a ballast resistor, may have been what saved it.
|
Tags
|
